manual:required_libraries
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
manual:required_libraries [2016/08/11 19:52] – [If your Boost version is too old] zenke | manual:required_libraries [2016/09/01 07:12] (current) – zenke | ||
---|---|---|---|
Line 12: | Line 12: | ||
It might happen that your distribution' | It might happen that your distribution' | ||
+ | Then download and build boost from source (with MPI support). To that end, follow the instructions found in the MPI section of the boost website http:// | ||
- | Then follow download and build boost from source (with MPI support). To that end, follow | + | Before you [[compileauryn|build Auryn]] make sure to delete the '' |
- | http:// | + | |
- | Before | + | ==== Troubleshooting common problems ==== |
- | ===== Known Issues ===== | + | If you can compile your Auryn programs, but you see an error along these lines |
+ | <code shell> | ||
+ | ./ | ||
+ | </ | ||
+ | it's probably because you have installed Boost under the default path '' | ||
+ | You could for instance add the following to your '' | ||
+ | <code shell> | ||
+ | export LD_LIBRARY_PATH=$LD_LIBRARY_PATH:/ | ||
+ | </ | ||
- | * Spike-loss and random crashes experienced with with process numbers that were not a power of two. (OpenMPI 1.4.3) | ||
- | * Random communication freezes for large messages (i.e. caused by synchronization in the network -> many spikes in short time intervals). | ||
- | When compiled against MPICH2 these problems did not occur. | + | See also [[known issues]] |
manual/required_libraries.1470945160.txt.gz · Last modified: 2016/08/11 19:52 by zenke